Remescar

Crow’S Feet

189 AED

 Remescar Crow’s Feet is specially formulated to address crow’s feet around the delicate eye area.

Remescar Crow’s Feet is an instant and effective cream which helps to reduce and diminish the appearance of crow's feet with just one single application per day.

Benefits:

  • Reduces the appearance of crow’s feet in just a few minutes!
  • INSTANT visible results
  • Effective from 1st application
  • Clinically proven

Its revolutionary technology eWRINK immediately targets and tightens skin structures around the eyes, by using a unique combination of plant silicones, clay minerals, phyto-saccharides and concentrated glucoside particles which will fill in wrinkles and rejuvenate the skin.

    Step 1: Wash your face gently and pat dry.

    Step 2: If you are using a moisturizer (day cream or eye cream), always allow time for your moisturizer to be fully absorbed before applying Remescar Crow's Feet.

    Step 3: Squeeze out a small amount of Remescar Crow’s Feet on your fingertip. You should aim for the size of a grain of rice; any less will not be enough, and any more is generally too much and won’t fully absorb into the skin or could cause sensitivity.

    Step 4: Rub the cream between your 2 index fingers until the cream becomes colorless (5 to 10 seconds). Make sure there is still enough cream between the fingers. In case it doesn’t feel wet anymore, take a small amount on your fingertip again. This is one of the key factors to make Remescar Crow’s Feet work correctly.

    Step 5: Gently apply the cream with one finger, on the area where crow’s feet are. Blend in using a light gentle tapping motion until the cream completely absorbs into the skin. You should avoid using the cream too close to your eye because the product will spread when it warms up with your body temperature.

    Step 6: Remain expressionless for 2-3 minutes while the product dries to achieve dramatic results (fanning will accelerate the process). Simply tissue off the excess of cream with a bit of water if too much cream is applied. Wash hands and close the tube after use.

    To Remove: Cleanse applied area with water and pat dry.

    For under makeup: First, apply your usual products (eye serum, daily moisturizer, etc.) and allow time for these products to penetrate the layers of your skin (a minute or two). Then you can apply a very thin layer of Remescar Crow’s Feet to the targeted area as instructed above. If you see a white residue you have either used too much product or did not use moisturizer. Simply tissue off the white residue with a bit of water. Once the product has dried, apply your makeup as usual.

    Note: Oil-based makeup may reduce the effectiveness of Remescar Crow’s Feet

    Note: Make sure to not use Remescar Crow's Feet with Remescar Eye Bags & Dark Circles on the same skin area, as this could give some white residue or cause sensitivity.